Campbell NL115 Manuale Scaricare il pdf (Pagina 11)

Section 1. NL115 Ethernet/CompactFlash

Module Overview

Step 2 – LoggerNet Set-up

The next step is to run LoggerNet and configure it to connect to the datalogger

via the Ethernet port.

a. In LoggerNet’s Setup Screen press Add Root and choose IPPort. Input

the datalogger’s IP address and port number. The IP address and port

number are input on the same line separated by a colon. (The

datalogger’s default port number is 6785. It can be changed using Device

Configuration Utility or by modifying its value in the Status Table. )

b. Add a PakBus Port and set the desired baud rate.

c. Add the datalogger (CR1000 or CR3000). Input the PakBus address of

the datalogger.

FIGURE 1-2. LoggerNet Setup

1-5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Nessun commento

Campbell NL115 Manuale Pagina 11