Campbell CM110 Manuale Utente

CM110, CM115, CM120 Tripod Installation Issued: 3.3.14 Copyright © 2005-2014 Campbell Scientific, Inc. Printed under licen

CM110, CM115, CM120 Tripod Installation 2 2. Specifications CM110 CM115 (see note 3) CM120 (see note 3) Height w/mast insert: 3 m (10’) 4.7 m (15.5’

User Manual 3 3. Tools List (for tripod, mast and crossarm) 1/2” and 7/16” open end wrenches adjustable wrench socket wrench with 1/2”and 7/16” deep

CM110, CM115, CM120 Tripod Installation 4 should be disturbed as little as possible, but brush and tall weeds should be removed. Stand the tripod base

User Manual 5 Figure 5-2. Tripod Mast and Insert The tripod base has two sets of right-angled holes for attaching the mast; typically the lower set

CM110, CM115, CM120 Tripod Installation 6 Figure 5-3. Mast Attachment to Tripod Base Secure the mast in the upright position by installing the lo

User Manual 7 Figure 5-4. Mast Lock Bracket Locking Bracket Lower Tabs Pin A B C

CM110, CM115, CM120 Tripod Installation 8 5.3 Installing the Guy Kit The CM115 and CM120 tripods include a guy kit; the guy kit is an option for the

User Manual 9 Figure 5-6. Guy Cinch and Lever Arm Phillips Screw Lever Arm “Open” Hook Lever Arm “Closed”

CM110, CM115, CM120 Tripod Installation 10 Figure 5-7. Mechanical Drawing of Guy Hook and Case 5.3.1 Guy Duckbill Anchor Kits Duckbill anchors are

User Manual 11 It is important that the anchors be driven at the same angle as the guy wires. Insert the drive bar into the anchor body and drive the

CM110, CM115, CM120 Tripod Installation 12 5.3.2 Lowering Mast after Attaching Guy Wires Once the guy lines have been adjusted the lever arms can be

User Manual 13 5.5 Tripod Grounding Place the clamp over the ground rod and drive the rod (close to the centre of the tripod) using a sledge hammer o

CM110, CM115, CM120 Tripod Installation 14 Figure 5-12. Lightning Rod and Tripod Grounding Lug Ground Lug Ground Wire Enclosure Ground Lug En

User Manual 15 5.6 Enclosure Attachment The ENC 10/12, ENC 12/14, ENC 14/16, and ENC 16/18 enclosures can be ordered with mounting brackets for the C

CM110, CM115, CM120 Tripod Installation 16 5.6.2 Enclosure Mounting to Tripod Leg An enclosure ordered with the –LM bracket has a bracket on each sid

User Manual 17 Figure 5-14. Enclosure with the –LM Bracket Keyhole Notch Phillips Head Screw U-Bolt Bracket –LM Bracket A B C

CM110, CM115, CM120 Tripod Installation 18 6. Sensors, arms and brackets This section describes a range of crossarms and brackets that are used to mo

User Manual 19 6.1.1 CM200E Crossarms and the CM210E Crossarm Mounting Kit CM200E series crossarms include a CM210E bracket as shown in Figure 6-1.

CM110, CM115, CM120 Tripod Installation 20 Figure 6-2. NU-RAIL® Fitting 2) An alternative to the NU-RAIL® bracket, is the CM220 bracket, fitted in

User Manual 21 6.1.3 Vector Instruments Wind Speed/Direction Sensors and the 011E Crossarm The 011E crossarm sensor mount is also supplied with a CM2

Guarantee This equipment is guaranteed against defects in materials and workmanship. This guarantee applies for twelve months from date of delivery.

CM110, CM115, CM120 Tripod Installation 22 6.1.4 Pyranometers and Solarimeters using the CM225E Pyranometer Mounting Stand The CM225E Pyranometer Mou

User Manual 23 6.1.5 Satellite Antenna using the CM230 Adjustable Angle Mounting Kit The CM230 mounts an antenna (25-38 mm OD) to a mast or vertical

CM110, CM115, CM120 Tripod Installation 24 Figure 6-6. CM235 Magnetic Mounting Stand

User Manual 25 6.1.7 Temperature and Humidity Probes – in the RM Young Gill Radiation Shield or the Met 20/21 Radiation Shield Radiation Shields are

CM110, CM115, CM120 Tripod Installation 26 6.1.8 CM216E Mast Mounting Kit The CM216E provides a 27 mm OD (3/4” IPS) or 33 mm OD (1” IPS) mounting pip

A-1 Appendix A. Tripod Tote Bag The Tripod Tote Bag is an option for the CM110 series tripods. The bag is constructed of nylon, with a main compartm

CAMPBELL SCIENTIFIC COMPANIES Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com • info@campbel

PLEASE READ FIRST About this manual Please note that this manual was originally produced by Campbell Scientific Inc. primarily for the North American

i Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to spe

ii Appendix A. Tripod Tote Bag ..... A-1 Figures 1-1. CM110 Tripod with Optional Guy Kit ...

1 Tripod Installation Manual Models CM110, CM115, CM120 1. General The CM110 (3 m), CM115 (4.7 m), and CM120 (6.4 m) tripods are corrosion-resistant